User's Manual

3
Specifications
If a Sensor Fails the Sensor Test
If sirens do not beep when a sensor is tripped, use an ITI RF
Sniffer (60-401) test tool to verify that the sensor is trans-
mitting. Constant beeps from the RF Sniffer indicate a run-
away (faulty) sensor. Replace the sensor.
To improve sensor communication, you can:
❑ reposition the sensor
❑ relocate the sensor
❑ if necessary, replace the sensor
To reposition a sensor:
1. Rotate the sensor and test for improved sensor commu-
nication at 90 and 180 degrees from the original posi-
tion.
2. If poor communication persists, relocate the sensor as
described as follows.
To relocate a sensor:
1. Test the sensor a few inches from the original position.
2. Increase the distance from the original position and
retest until an acceptable location is found.
3. Mount the sensor in the new location.
4. If no location is acceptable, replace the sensor.
To replace a sensor:
1. Test a known good sensor at the same location.
2. If the transmission beeps remain below the minimum
level, avoid mounting a sensor at that location.
3. If the replacement sensor functions, contact ITI for
repair or replacement of the problem sensor.
Operating temperature range:
Specifications
Compatibility ................Simon, Concord Express, Quik-
Bridge
Case dimensions............L = 4.5” X W = 1.2” H = .94”
Operating temperature...10° to 120° F° ()
Storage temperature ......-29° to 140° F (-34° to 60° C)
Humidity .......................90% relative humidity
non-condensing
Battery...........................2 AAA Alkaline batteries
Transmitter frequency...319.5 MHz
Transmitter Range.........500 feet open air
FCC Notices
This device complies with FCC Rules Part 15. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by Interlogix, Inc. can
void the user’s authority to operate the equipment.
FCC ID: B4Z-679A-DWS