User's Guide

4
Chapter 1 Introduction
INTRODUCTION
Call Before
Showing (CBS)
Control access by requiring the buyer’s agent to call the listing
agent to obtain a CBS code.
Input Update Enter the code to update the XpressKEY.
About View details about the XpressKEY and update the key.
Vibrate Toggle the vibration on or off.
Display PIN/
Shackle
Display the PIN or Shackle code on or off.
Change PIN Customize your Personal Identication Number.
Languages Change the language to French, Spanish, or English.
Current Time View the current time from the top status bar.
Battery Status
View from the top status bar how much battery is left in the key,
when it is charging, if the battery is too hot and when to replace
the battery, respectively.
Battery
The XpressKEY has a rechargeable, replaceable battery that was specically designed for XpressKEY. The
battery should last several years (with average use) before it is replaced. When replacing the battery, only use
the approved Supra XpressKEY battery. You can order the battery online through SupraWEB.
WARNING: Do not leave the XpressKEY or battery exposed to high (over 131°F/55°C). Lithium Ion
batteries have a risk of re, explosion, and burns. Do not short-circuit, crush, incinerate, or disassemble
the battery. Burning these batteries will generate toxic fumes. Cool the exterior of the batteries to
help prevent rupturing. In case of re, use dry chemical, alcohol resistant foam, or carbon dioxide
re extinguishers. For specic information, see the battery manufacturer’s warnings and cautions at
www.na.industrial.panasonic.com.
Charging
Use the included micro-USB, off-the-shelf micro-USB,
or car charger to charge the XpressKEY battery. When
the battery is fully charged, the battery icon shows full.
It takes about three (3) hours to fully charge.
A warning displays on the XpressKEY when it has 25%
battery life remaining. A second warning displays when
there is 15% battery charge remaining. The XpressKEY
will automatically shut down when the battery charge
is at 5% and must be charged before the next use.
To preserve battery power, the XpressKEY goes into
Standby mode after 60 seconds of inactivity.
If the Charge NOW warning displays, you will be able
to open a keybox after a minimum 10 min of charging,
then a full charge to the XpressKEY is required.
Charging
Port