User's Manual

2
Figure 4. Installed TRAC-Lid
— Make sure TRAC-Vault BT devices is mounted ush
with masonry surface and the masonry screws are only
installed directly into brick.
— Minimize all gaps between back of TRAC-Vault BT
devices and masonry surface.
Rendered Wall Installation:
1. While holding the vault in the desired position on the
wall, locate the four mounting holes away from mortar
lines and the edge of the wall.
2. Using a marker, trace the location of all four (4)
mounting holes (see Figure 1).
3. Using a drill with an 8 mm masonry drill bit, drill each
hole to a depth of 105 mm.
4. Verify each hole aligns with the four (4) holes in the
back of the vault.
5. Clean out the debris from all four (4) holes.
6. Insert one of the HECO mounting screws onto the
chain mounting bracket (see Figure 2).
7. Place the TRAC-Vault up to the wall (drain hole down)
and insert each mounting screw all the way through
the mounting holes in the vault, with the chain
mounting bracket in the lower left hole.
8. Tighten all four (4) screw heads in the order shown in
Figure 1untiltheyareushwiththebackofthevault,
and behind the vault lip.
9. Using the appropriate driver, tighten all four (4) screws
into the wall a little at a time until all four (4) screws
are secure and the vault is tight against the wall.
Figure 3. Optional Tamper Switch
Figure 5. Side view, TRAC-Vault BT installed through the wall
Lock washer
Nut
TRAC-Vault
TRAC-Lid BT
Drain hole
Lid chain
attachment
Vault
chain bracket
Wall
Back plate
All-thread rod
Nut
Lock nut
Fender washer
Indicator
light
TRAC-Lid BT
TRAC-Vault
Thumb lever
Tamper switch
adjustment screw
1 Normally open
2 Normally closed
3 Common
To alarm
AMP FDVH-187C
quick connector
14/16 AWG wire