User manual

Arc Contouring
The DP700 calculates positions for rough machining an arc or radius. The message display
prompts the user for various parameters it needs to do the calculations.
Once the DP700 completes the calculations, the axis displays show the co-ordinates, which
are point to point positions along the arc. The operator works to zero for each hole location.
See example below.
How to navigate to arc contouring function.
Until message display shows
,
funcs
arc
Example
Message display shows
arc
centre
3.35000
2.36000
Enter centre co-ordinates
(See using set mode P19)
arc
radius
Enter the arc radius
(See using set mode P19)
2.70000
arc
start
Enter starting point
(See using set mode P19)
arc
tool dia
Enter tool diameter
(See using set mode P19)
0.50000
Note: At this point you can use the keys to navigate back and forth through the above
menus.
arc
go
-3.34079
-4.81000
arc go
hole 01
Note: The numbers appear as negative
values because the operator works to
zero.
2.25000
4.82600
arc
end
Enter end point
(See using set mode P19)
5.35000
4.17400
arc
Arc type
Selects internal or external
cut
int
arc
max cut
Enter maximum cut
(See using set mode p19)
0.15000
Mill Functions
Y axis
Starting Point
Ending
Point
Datum
X axis
Arc
Centre
Radius
0.5” Tool
Diameter
Internal
Cut
Maximum
Cut
0.15”
4.826”
4.174”
2.36”
2.7”
2.25”
3.35”
5.35”
Navigate through the sequence of holes by using keys
27