User manual

Setting Up The Unit
17
Reset Setup
This setting enables the user to reset the DP700 unit back to factory defaults.
There are three factory default settings:
generic
lathe
nnill
Default as Lathe / Mill
Default as Mill
Default as Lathe
Press the axis select key next to the ‘X’ axis to cycle through options
Please note: When the DP700 is defaulted as a lathe the X axis default setting is DIA
and therefore the X axis will measure double.
OEM Defaults: The DP700 may have OEM default settings specific to a machine. In
this case the DP700 will only display one reset option. This reset will default all
parameters to match the machine it has been provided with.
Press to accept the option.
Press to accept.
Sleep Setup
This setting enables the user to define an automatic sleep mode after a period of time. The
user either leaves the default setting at 0 which deactivates the sleep mode, or inputs a value
(in whole minutes) for when the sleep mode is initiated after no operation of the DP700.
To exit sleep mode, simply move an axis or press any key.
There are two settings:
0
Sleep Mode deactivated
Sleep Mode Active
15
(Default)
Note: The number in the display is the value in whole minutes before the DP700 will enter
sleep mode.
Enter the required value via the numeric keypad, Press to accept the value.
reset
sure?
no
Press the axis select key next to the ‘X’ axis to cycle between yes and no.