User manual

Setting Up The Unit
Beep Setup
This setting enables the user to have the option of an audible tone on pressing any of the
keys on the DP700.
There are two settings:
off
on
Key Beep on
Key Beep off
Press the axis select key next to the ‘X’ axis to cycle through options
Functions Setup
This setting enables the user to choose the functions that are required to be used with the
DP700. Functions that are switched off will not show in the function menu or message display.
on
off
set func
tools
set func
Taper
set func
summing
set func
pcd
set func
line
set func
arc
set func
polar
set func
log
Press the axis select key next to the ‘X’ axis to cycle through options
Function On
Function Off
Press the key to Navigate through functions
the list of functions can be found below
Tool Offsets
Taper
Axes Summing
Pitch Circle Diameter / Bolt Hole Circle
Line Hole
Arc Contouring
Polar Co-ordinates
RS232 Data Logging
press to exit
set func
sdms
Sub Datums
16