User Guide

English
7
MODE3: D2D mode. The light will turn on at 100% brightness at night,
and automatically turn o in the morning. Motion detection
will not work in this mode.
HOLD TIME
Set the duration of the light to 10s/1min/5min/10min once motion is
detected.
SENS
Set the sensor sensitivity for motion detection. Set to LOW, the
sensitivity is low. Set to HIGH, the sensitivity is high.
LUX
Set the luminance detection. Set to DAY, the light will trigger during
the day. Set to NIGHT, the light will trigger only at night.
1. The remote controller has memory function, which means that it
can start at your last choice on mode and seings.
2. The security light is controlled by the IR remote controller. To make
it work perfectly, please point the remote controller to the light and
make sure there is no obstacle between the light and the remote
controller for beer signal response.
3. After a period of usage, the remote controller might run out of
baery and become insensitive or the control distance may be
shortened. If the remote controller is not working, please try to
replace its baery as per instructions shown below. If the remote
controller still fails to work after replacing new baery, please
contact the seller for help.
Note: