LED Security Light User Guide
English LED Security Light User Guide Thank you for ordering from Ustellar. Set-up is easy and takes only a few minutes by following the instructions. AC Power Hardwired, NOT Solar Powered, NOT Battery Powered. NOT Dimmable. Brightness NOT adjustable. Warning (1) Please check if the light and the parts are intact before installation. (2) Make sure to cut off power before installation. (3) Please do not place this light in corrosive conditions.
English 1. Parameters UT88125 Model 55W Wattage 5000K Color Temperature Max Luminous Flux 5500lm Input Voltage AC120V Frequency 50/60Hz 180° Max Detection Range 60Ft (<24℃) Max Detection Distance No Dimmable IR Rmote Controller Controlled By Battery for Controller CR2025 Life Expectancy 50000Hr -20℃-40℃ Working Temperature 2. Dimension 230mm/9in 320mm/12.6in 135mm/5.3in Weight:1.92lb/0.
English 3. Components IR Remote Controller LED Security Light 2 Screws Gasket 3 Wire Connectors Mounting Bracket Mounting Bolt Rubber Plug 4.Installation Safety Information： This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Turn power OFF before installing. This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.
English L L—Black G—Green/Yellow N N—White Installations： For best performance, mount the light about 6.5-8ft above the ground. If the light is mounted higher than 8ft, aiming the sensor down will reduce the coverage distance. 1. Turn off the power. 2. Install the mounting strap as shown with two screws that fit your juntion box. 3. Tighten the wires with wire connectors. L should be connected to Black wire, N should be connected to White wire.
English 4. After mounting the light, apply silicone sealant completely around the perimeter of the cover plate where the back of the cover plate meets the mounting surface. Silicone sealant prevents water from seeping into the junction box. 5. Remove the plastic sheet from the bottom of the remote controller so as to activate the controller.
English 5.Remote Controller Manual Mode Sensor Mode Manual Mode: Control the security light constantly ON or OFF. Sensor Mode: MODE1: PIR mode. When people go through the sensor area, the light will turn on at 100% brightness. After people leave, the light will turn off. MODE2: DIM mode. When people go through the sensor area, the light will turn on at 100% brightness. After people leave, the light will turn to 20% brightness.
English MODE3: D2D mode. The light will turn on at 100% brightness at night, and automatically turn off in the morning. Motion detection will not work in this mode. HOLD TIME: Set the duration of the light to 10s/1min/5min/10min once motion is detected. LUX: Set the luminance detection. Set to DAY, the light will trigger during the day. Set to NIGHT, the light will trigger only at night. SENS: Set the sensor sensitivity for motion detection. Set to LOW, the sensitivity is low.
English 4. There is a LED indicator in the motion sensor. In Manual Mode, the indicator will turn to green. In Sensor Mode, the indicator will turn to red. 5. The motion sensor is less sensitive if in a radial movement. as shown below (picture 1). The motion sensor is more sensitive if in a lateral movement, as shown below (picture 2). The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole luminaire shall be replaced.
English Contact Us Have some issue? No worries! Please reach us via these channels. Our customer services team is more than happy to help. www.ustellar.com support@ustellar.com Manufacturer: Shenzhen Ustellar Technology Ltd.
Manual Version: UT88125W-DW-US / V1.
