Specifications

2. Setting Distance
 The sensor can be adjusted clockwise or counter clockwise per requirement,, for the purpose of
changing the detection scope
 Adjust the “distance” switch to D2D position,the lamp will turn ON at dusk and turn OFF at
Dawn when detect the motion.
 Adjust the “distance ” switch can set the sensitivity of the sensor means changing the
sensor’s detection distance, it can be positioned to high,mid and low.
 To determine the detection scope of motion sensor need to perform a simulation test:
walking in an across the front of the motion sensor.
The motion sensor is less sensitive if in a radial movement. As shown below (picture 1).
The motion sensor is more sensitive if in a lateral movement. As shown below (picture 2).
3. Setting MANUAL MODE
Adjust both the “distance” switch to D2D position,and “TIME” switch to TEST position at the same
time. ,then it can fitting into “Manual” mode.
Installations:
For best performance,mount the fixture about 8ft(2.4m) above the ground.Note: If fixture is
mounted higher than 8ft(2.4m),aiming the sensor down will reduce coverage distance.