Specifications

ManualsBrandsUstellar ManualsElectrical EquipmentSmart LED Security Lights

Motion Activated Security Light

Features:

 Turns on lighting when motion is detected.

 Automatically turns off lighting off.

 Photocell keeps the lighting off during daylight hours.

 LED indicates motion was sensed(day or night).

This package includes

SPECIFICATIONS:

Power Source:120V Detection Range: 180°

Power Frequency: 60Hz Working Temperature: -20~+40℃

Ambient Light: <10-2000LUX Working Humidity: <93%RH

Time: TEST（5Sec）1Min.3Min.10Min Distance: L.M.H 18m.max (<24℃)

Load: 45W.LED Operating: Test . Motion Activated. Manual

Lumen:4000lm CRI>80

Color Temperature: 6000K

Operations:

1. Setting TIME

 Adjust the switch of “Time” can set the duration of lighting time when the sensor

detect an object movement, then it will turn the light on (The duration time when the objects

stop movement), it can be set to TEST,1MIN,3MIN,10MIN).

 When set on TEST(5sec) position, it is used to test for installation, which is not controlled by

ambient lux, and the light will stay on for 5 seconds.

Mode

Light ON -Time

Works: Day Night

Test

5 Seconds

× ×

Motion

1,3 or 10 Minutes

× ×

D2D

1,3 or 10 Minutes

Manual

Light keep on Under this mode

× ×

Summary of content (4 pages)

PAGE 1
SPECIFICATIONS: Motion Activated Security Light Power Source:120V Detection Range: 180° Power Frequency: 60Hz Working Temperature: -20~+40℃ Ambient Light: <10-2000LUX Working Humidity: <93%RH Time: TEST（5Sec）1Min.3Min.10Min Distance: L.M.H 18m.max (<24℃) Load: 45W.LED Operating: Test . Motion Activated.
PAGE 2
. Setting Distance  The sensor can be adjusted clockwise or counter clockwise per requirement,, for the purpose of Adjust both the “distance” switch to D2D position,and “TIME” switch to TEST position at the same changing the detection scope  3. Setting MANUAL MODE time. ,then it can fitting into “Manual” mode. Adjust the “distance” switch to D2D position,the lamp will turn ON at dusk and turn OFF at Dawn when detect the motion.
PAGE 3
 Shut off power.  Install the mounting strap as shown using two screws that fit your juntion box. Maintenance:  Route the light control`s wire and fixture wires as shown.Secure with wire connectors.  Care and Cleaning  To prolong the original appearance, suggest to clean the light fixture with clear water and Note: L should be connected with the Black, N should be connected with White. a soft, damp cloth.
PAGE 4
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.