Technical information

Page 49
Functional Detector Bases
Functional detector bases use a common moulding which incorporates a double side circuit board which enables electrical connections to be made on the
top and bottom of the functional base. This allows the functional bases to be retrofitted into new and existing universal bases or alternatively the depth and
cost of the installed detector can be reduced by using the functional base instead of the universal base. This feature enables additional line isolators and
sounders to be easily added during commissioning. In addition, changes to the building during it’s life can be easily adapted to, by retrofitting sounders and
relay outputs to existing detection points.
When functional bases are fitted to universal bases, they automatically lock into position. Removal is then achieved using the detector removal tool. This
feature ensures that the detector and functional bases are removed separately.
When used on addressable systems, the MC900 takes the same address as the detector. This increases the number of devices on a loop and significantly
improves fault monitoring. Any attempt to remove the functional base will generate a fault on the system.
Datasheet - Product Code PSF101 “M600/900 Low Profile Detector Bases”
Manual - Vol01B-03-D2 “Detectors Fire Manual”
A plastic cap which fits onto the
601SB/601SBD/602SB/602SBD Sounder Base to
enable these bases to operate as a sounder
without fitting a detector.
Product Codes
557.001.040.A
Mark II Sounder Cap (ADT Branded)
557.001.040.T
Mark II Sounder Cap (Thorn Branded)
557.001.040.Y
Mark II Sounder Cap (Tyco Branded)
.
A new low current range of sounder bases for use
with Conventional and Addressable Fire Alarm
Control Panels.
Features
• Manufactured to EN54 part 3
• Integral sounder and detector base
• Volume and tone adjustable after installation
• Low Power Synchronisation
• Do not require use of a standard base (maybe
installed directly onto a standard besa box)
Product Codes
577.001.035
601SB Conventional Sounder Base
577.001.037
601SBD Conventional Diode Sounder Base
577.001.036
602SB 2 Wire Line Powered Sounder Base
577.001.038
602SBD 2 Wire Line Powered Diode Sounder
Base
516.800.911
901SB Universal Sounder Base
516.800.912
912SB Universal UL Sounder Base
Please See Following Applications Table for
Further Details.
Tyco MKII Sounder Bases
A simple Volume Adjustment Tool, specific to the
task of sounder volume selection on the “variable-
volume” range of Tyco MKII Sounder Base
Devices.
Sounder volume can be easily varied between the
maximum 90dBA and minimum 68dBA-volume
settings, using this simple, functional tool.
Note: Sounder Base Devices are supplied with
the volume pre-set to maximum volume.
Product Code
517.050.015
Volume Adjustment Tool
Tyco MKII Sounder Cap
Volume Adjustment Tool