Service manual

6 • Service Menus
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
6-19
6.8 System
Information
USB Device
This screen shows if a USB device is connected to the system and the type
(“MCP” or “HUB”), basically letting you know USB communications are
working. It does not imply that the USB device itself is fully functional.
Internal Information
Lists information about the system, such as the UIC version, PCN, SN#, rates
level, software levels, etc.
Flash File Info
Allows you to maintain flash files that are used to boot up or run the system.
View Flash File
Provides a list of the flash files on the system.
Delete Flash File
Allows you to delete a flash file. IMPORTANT: Do not delete a flash file un-
less directed to do so by Pitney Bowes Engineering or a call agent.
6.9 Enable
Features
This option allows you to enable or disable features. Enter the code of the
feature you want to enable or disable: Then press Accept. The message
shows whether the feature is enabled or disabled or the code you entered is
invalid.
NOTE: Because features are downloaded from the Data Center to the cus-
tomer’s machine automatically, use this function only if directed to do so by
Engineering or a Call Agent.
6.10 Meter
Withdrawal
This option allows you to move any remaining postage from your machine to
the Postage By Phone
®
account. Normally this is done if the machine is to be
taken out of service. See section 4.5 for specific steps.
NOTE 1: Make sure the “return flag” is set on the machine before withdraw-
ing funds. If not sure, call Postage-By-Phone support.
NOTE 2: The system must be connected to the Pitney Bowes Data Center
before you begin.
6.11 Mail
Simulation
Not implemented at time of publication of this manual. Use the Seal-Only
mode to test mail feeding.
✍
TIP: Access the Ser-
vice Menu by typing
6946 and pressing
Refill Postage key.