Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-67
WOW Section of Feeder/WOW Module (use for DM475)
4. Remove one screw for brass grounding fingers on right side of bottom
chassis.
Brass Fingers
Screw for
Brass Fingers
5.56 Feeder/
WOW
Registration
Wall Alignment
5. Loosen (do not remove):
• Two screws on bottom of metal frame for feeder/WOW control board
Two Screws on
Bottom (loosen)
• Six long, washer-head screws for load cell assembly in oval adjust-
ment holes (three in front, three in back)
Three Long
Screws in Back
(loosen)
Three Long
Screws in Front
(loosen)
(this long screw is just to the right of visible screw in photo)