Service manual

5 • Removal & Replacement
5-64 DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
WOW Section of Feeder/WOW Module (use for DM475)
5.55 WOW
Load Cell
Assembly
1. Remove WOW unit chassis (section 5.51).
2. Remove feeder/WOW control board on its bracket (section 5.41)
3. Remove WOW upper transport assembly (section 5.47)
4. Remove lower transport WOW assembly (section 5.53).
5. Release tensioner and remove belt on motor drive pulley.
6. Remove the motor drive pulley (consists of pulley, e-clip brass washer
and plastic washer).
Screws
(white circles)
Position Pins
(black circles)
7. Remove seven screws holding wall plate to load cell unit.
Load Cell
Wall Plate
Belt for Motor
Drive Pulley
Motor Drive
Pulley
Plastic Washer
Brass Washer