Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-63
WOW Section of Feeder/WOW Module (use for DM475)
4. Reassemble in reverse order. Keep in mind the following:
Make sure the shaft is put back in correctly (short end faces the rear
and some are “d” shafts).
5.54 Lower
WOW
Transport
Components
D. Remove right black plastic stiffener (one screw).
E. Remove e-clip and slide off middle belt roller.
F. Remove left black plastic stiffener (one screw).
G. Release tension spring on both sides.
H. Remove tension spring assembly on front (one screw) and only
loosen the tension spring assembly on the back. “Work out” shaft.
I. Remove belts.
Black Stiffener
Cover
WOW
Drive
Belts
Tension Spring
Assembly (one
removed)
Middle
Roller
E-Clip
Put the two belts on first.
Belts should go in grooves in rollers.
Black plastic stiffeners are keyed to go in one way only
Compress springs to allow belts to go over rollers
Release tension when belts are installed, spin belts, then retighten
tensioners
Perform the feeder/WOW Registration Wall Alignment (section 5.56)
“D” Shaft End