Service manual

5 • Removal & Replacement
5-60 DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
WOW Section of Feeder/WOW Module (use for DM475)
5.53 Lower
WOW
Transport
Assembly (as
a whole unit)
1. Remove the feeder/WOW module cover (section 5.39).
2. [Optional, but recommended] Remove WOW unit chassis (section 5.51).
3. Remove the WOW deck (section 5.50).
4. Release tension on left belt (looking from behind) and remove e-clip
from middle pulley.
Tensioner Screw for Left Belt
Middle Pulley
Left Belt
5. Remove plastic hold-down on encoder bracket over middle pulley. Re-
move encoder bracket and encoder wheel (one screw). NOTE: When
removing pulley, do not loose pin in shaft. Slot in back of pulley aligns
with pin.
Encoder and Hardware Over Middle Pulley
Encoder and
Middle Pulley
Removed
Pin on shaft
(horizontal to
fit in slot in
back of pulley)
Slot in Back
of Pulley
6. Disconnect the width sensor flex cables from the plastic clip under the
lower WOW transport. If you have not removed the WOW unit chassis,
you will need to use your hand to feel for the clip under the lower WOW
transport assembly and unfasten the clip.
Plastic Clip for Sensor
Harnesses (Circled)
Lower WOW
Transport
Assembly