Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-59
WOW Section of Feeder/WOW Module (use for DM475)
5. Remove two screws holding motor to wall plate. Note that the motor
plate is slightly off angle to the wall plate. This is normal.
Screws for Motor (Circled)
5.52 WOW
Transport
Motor
6. Slide motor towards printer and remove.
7. Reassemble in reverse order. Keep in mind the following:
• Ensure all cable hold-downs are properly closed around cables. Vi-
bration in the cable can affect the load cell’s ability to “zero” as well
as its accuracy
• Perform the feeder/WOW Registration Wall Alignment (section 5.56).