Service manual

5 • Removal & Replacement
5-58 DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
WOW Section of Feeder/WOW Module (use for DM475)
5.52 WOW
Transport
Motor
1. Remove WOW unit chassis (section 5.51).
2. Untension the motor drive belt.
3. Disconnect motor harness cable from junction board. Unclip harness
from two clips in and under the lower WOW transport assembly.
Tensioner
Two Plastic Clips
for Motor Harnesses
(Circled)
WOW Transport
Motor
Motor Drive Belt
Lower WOW
Transport
Assembly
Motor Harness Cable at
Feeder/WOW Junction
Board
4. Remove two screws fastening feeder/WOW junction board and move it
up slightly to expose screw for WOW transport motor behind it.
Screws (Circled) for
Feeder/WOW Junction
Board