Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-55
WOW Section of Feeder/WOW Module (use for DM475)
5.51 WOW
Unit Chassis
(as a whole
unit)
2. Remove the feeder/WOW module cover (section 5.39).
3. Undo two plastic clips and remove feeder harness (purple and orange
wires) from feeder/WOW control board.
1. Locate and lock-down the three WOW load cell shipping screws. The
two front screws are accessed via notched holes in the feeder/WOW
deck (left photo below), while the back screw is accessed through a
hole in the interface cable compartment (right photo below).
Access Hole Inside Interface Cable Cavity
(interface cables disconnected)
Notched Access Holes on Deck
Plastic Clips
Purple Feeder Harness
Orange Feeder Harness
4. Remove the two screws securing the back of the feeder/WOW control
board metal frame and one screw holding metal frame to bottom chassis.
Feeder/WOW Control Board
Bottom Screw for
Chassis
Two Screws on Back
of Metal Frame