Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-51
WOW Section of Feeder/WOW Module (use for DM475)
5.48 WOW
Upper
Transport
Arms
Assembly
1. Remove the WOW upper transport (section 5.47).
2. Release spring tension from each roller (eight total).
3. Remove e-clips on each shaft (and bushing on back side of thickness
encoder shaft).
4. Note the position of the “tails” of the arms, then remove arms assembly.
5. Reassemble in reverse order. Make sure the ”tails” of the arms are posi-
tioned properly (see figures).
E-Clip and Bushing
“Tails” of the Roller Arms (Circled)