Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-47
WOW Section of Feeder/WOW Module (use for DM475)
5.43 Feeder/
WOW Junction
Board
1. Remove Feeder/WOW Control Board (section 5.41).
2. Unplug all connectors (three on top, three ribbon in the middle, and one
on bottom right) and remove two screws.
3. Reassemble in reverse order.
5.44 WOW
WS2 (Middle)
and WS3 (Exit)
Sensors
1. Remove Feeder/WOW Control Board (section 5.41).
2. Unplug purple harness (you may need to undo plastic clips).
3. Remove screw holding bracket to frame.
4. Remove screw holding sensor to bracket.
5. Reassemble in reverse order.
NOTE: Both sensors use the same part number.
Top Connectors
Middle Connectors
Bottom Right Connector
Screws
WS2 Middle Sensor
WS3 Exit Sensor