Service manual

5 • Removal & Replacement

5-46 DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)

WOW Section of Feeder/WOW Module (use for DM475)

5.42 WOW

Thickness and

Feed Encoders

1. Remove feeder/WOW Control Board (section 5.41). You only need to do

steps 1-6 from that procedure.

3. Unplug purple harness from encoder.

2. [Feed encoder only] Unlatch plastic hold-down to allow enough slack

to remove harness in step 6. Do this by squeezing in the tab that com-

presses the pin that fits in the hole.

Feed Encoder

Thickness Encoder

(Removed)

4. Remove screw holding encoder metal bracket to back wall.

5. Remove screw holding encoder to metal bracket and remove encoder.

6. Remove e-clip and washer from encoder wheel and remove wheel from

shaft.

7. Reassemble in reverse order

NOTE: When reassembling, use alignment nubs on back wall to align

encoder bracket to back wall when mounting. Don’t forget to re-install

plastic hold-down on feed encoder harness.

Purple Harness

Screw

Holding

Encoder

to Metal

Bracket

Encoder Wheel

Removed

Screw

For Metal

Bracket

Feed Encoder

Plastic

Hold-Down