Service manual

5 • Removal & Replacement
5-44 DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
WOW Section of Feeder/WOW Module (use for DM475)
5.41 Feeder/
WOW Control
Board (PCB)
1. Remove the feeder/WOW module cover (section 5.39).
2. Disconnect the white flex cable at the feeder/WOW junction board end. This
cable is held in just by its placement in the connector - no fastener is used.
4. Remove load cell cable (black) to board and its accompanying hold-
down screw.
5. Remove two screws on back of metal frame and one screw holding
metal frame to bottom chassis.
3. Undo two plastic clips and remove feeder harness (purple and orange
wires).
Feeder/WOW
Junction Board
White Flex Cable
(partially obscured)
Plastic Clips
Purple Feeder Harness
Orange Feeder Harness
Black Load
Cell Cable
Hold-Down
Screw
Bottom Screw for
Chassis
Two Screws on Back
of Metal Frame