Service manual

5 • Removal & Replacement
5-40 DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
Auto-Feeder (use for DM400c/DM450c/DM475)
1. Remove feeder upper cover
(section 5.25)
2. Unplug connector.
3. Remove screw and feeder
sensor PCB.
4. Reassemble in reverse order.
5.35 Feeder
Sensor (FS2/
WS1) PCB
Screw
PCB
Figure 5-120 Feeder Sensor PCB
Connector
Figure 5-121 Seal/No Seal Lever
1. Push cap assembly (figure,
right) in.
2. Turn cap assembly one-quar-
ter turn to remove cap and
spring.
3. Free lever.
4. Reassemble in reverse order.
5.36 Seal/No
Seal Lever
Cap Assembly