Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-37
Auto-Feeder (use for DM400c/DM450c/DM475)
7. Remove three screws as
shown in Figures 5-111 and
5-112, right, and detach roller
plate.
NOTE: Roller plate is aligned
to moistener deck by two
studs, one of which is shown
in Figure 5-112. Use care
when separating the roller
plate from moistener deck.
8. Push out the two bushings
that confine roller shafts; then
remove roller assemblies by
lifting out of cutouts.
Figure 5-111 Screw Removal, Left
E-Clips and
Bushings
Roller Assemblies
Figure 5-113 Roller Plate Removal
Figure 5-112 Screw Removal, Right
Stud
5.32 Feed Belt
Assembly