Service manual

5 • Removal & Replacement
5-36 DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
Auto-Feeder (use for DM400c/DM450c/DM475)
1. Remove feeder unit (section
5.28).
2. Release the release lever.
3. Remove spring and loosen
the belt tensioner screw as
shown in the figure, right.
4. Remove timing belt and
gear.
5. Remove two E-Clips, and
pulleys as shown at the
right.
6. Remove three bushings as
shown in Figure 5-110.
5.32 Feed Belt
Assembly
Release Lever
Spring
Loosen Screw
Timing Belt
Gear
Figure 5-108 Release Lever
Figure 5-109 Timing Belt/Gear Removal
Figure 5-110 Bushing Removal
E-Clips and Pulleys