Service manual

5 • Removal & Replacement
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
5-17
Printer/Base (use for all models)
5.15 Tape Feed
Unit
1. Remove rear cover (section 5.2), control panel (section 5.3) and sub-
cover (section 5.4).
2. Remove two screws as shown in Figure 5-52.
3. Carefully lift the tape feeder unit up. Note that a wiring harness is con-
nected to it. See Figure 5-53 below.
4. Disconnect harness as shown.
5. Remove the tape feed assembly.
6. Reassemble in reverse order.
5.15.1 Tape Motor
1. Remove tape feed unit as described above (section 5.15).
2. Remove two screws securing motor. See Figure 5-54 below.
3. Reassemble in reverse order.
Figure 5-52 Tape Feeder Mounting Screws Figure 5-53 Tape Feeder Harness
Figure 5-54 Tape Feed Motor
Figure 5-55 Tape Feed Roller Assembly
5.15.2 Tape Feed Roller Assembly
1. Remove tape feeder unit as described above (section 5.15).
2. Remove E-Clip and bearing from roller shaft. See Figure 5-55, above right.
3. Free roller assembly from tape feed housing.
4. Reassemble in reverse order.