Specifications

3-19
3 • Running Mail
SV62667 Rev. A
6. At the Services amount confirmation screen, select Done. A
screen displays with the amount of correction (the example used
in these steps is shown below):
11.08.28 ≡0.38≡
◄CLASS: Postage Corr
◄SCALE: x g
7. Take mail piece off of scale and run the mail piece through the
system so the that indicia prints on the upper right hand corner
of the back side of the envelope (opposite of where initial indicia
is printed). Alternatively, you can use a tape sheet to print the
correction indicia and place it to the left of the original indicia (for
parcels) or as instructed above for letters.
5. Key in the postage correction using appropriate decimal places
(in the example above, the value must be between $0.01 and
$0.50) and select OK.
11.08.28 ≡0.38≡
◄CLASS: Postage Corr
MAN WT: x g
Screen with Scale
Screen without Scale
Must be a non-zero
indicia amount
i
NOTE: If the meter printed a zero postage indicia ($0.00) instead
of the intended postage correction, it means you accidentally
keyed in a postage amount outside the range displayed in step
4. If this happens, simply redo this procedure but ensure that you
are keying in a value within the range displayed. Also, this time
use a tape sheet to print the postage correction.
Once you have printed the proper postage correction amount,
place the tape sheet to the left of the original impression (if room
provides) or affix the tape sheet in the upper right hand corner of
the other side of the mail piece.
Adding Postage to Correct a Mail Piece