Install guide

8
9
Step 9 Install the Scale (optional)
DM200LDM100i
DM200L
DM100i
Step 10 Print a Test Pattern
When prompted, insert a spare envelope
or a tape sheet for a test print.
Good test print - no missing lines Poor test print
If the test print is good, press the green Yes
button on the front of the meter.
If the test print is poor,
press No to perform additional maintenance.
A scale code is needed to calibrate the scale. If you have just attached
your scale, key in the correct scale code for your location. Codes for
each state can be found in the back of this guide on Page 19.
• Select Continue.
No
Yes/Enter



Step 11 Enter Scale Location Code
platform
base unit
Registration
Wall
For proper printing,
position mail flat
against registration wall
and gently slide mail to
the right on feed deck.
The system will detect
the envelope and
automatically guide it
through the printing
mechanism.
The optional scale consists of two pieces. Place the flat weighing
surface on top of the base unit, being sure the pegs on the weighing
surface fit into the corresponding holes in the base unit.
Position the two-piece scale as shown.
Now plug the connector on the bottom of
the base unit into the matching connector
on your system.
i