Specifications

Note: When loading your laminating film, check for film splices.
These rolls will be clearly marked. Splices are not common, but are
unavoidable. If you find a spliced roll, place it in the top position on
the laminator so that the splice can be monitored carefully. When
the splice is ready to come through the laminator, turn the drive and
heat off, allow the machine to cool, and rotate the roll of film by hand
so the film tension is very loose. Turn the drive switch on again and
allow the splice to run through. If necessary, keep turning the roll of
film by hand to keep it slack until the splice has passed through.
Caution: Do not apply excessive force to the ends of the mandrel
(i.e. with a hammer, etc.). Excessive force will damage the mandrel.
When loading the laminator, be sure the heat is turned off and the
machine is cool to avoid chance of burns.
Note: Film rolls must be centered on supply mandrels.
If the rolls are not aligned, hot adhesive will be deposited on the
heatshoes and rubber rollers, necessitating a cleaning operation.
Caution: When loading the laminator, be sure that the heat is turned
off and the machine is cool.
THREADING DIAGRAM
Figure 9-4
8
9
Photo 9-1
Photo 9-3
Photo 9-2