Owner manual

43 USG Exterior Ceiling Applications
Accessories
¹ When used with Paraline systems, Paraline compression post adapters must be purchased. The end plug of the compression
post is removed and replaced with the Paraline compression post adapter prior to installation. The Paraline compression post
adapter is not included with each compression post and must be purchased separately.
Application
1
Step 1 Fit top clip into the opening of the post.
Step 2 Snap compression post onto main tee bulb next to vertical hanger wire.
Step 3 Bring compression post to vertical with hanger and extend post for snug fit against structure.
Step 4 Loop spring clip around vertical hanger wire and connect to holes on top of post.
Step 5 Mechanically fasten end plug of post to main tee bulb.
Step 6 Fasten compression post to structure with the appropriate mechanical fastener.
top clip
hanger wire
compression post
spring clip
attachment holes
structure
spring clip
ceiling
bulb clip
(mechanically fastened)
top clip
(mechanically fastened)
Compression Post