Manual

Page 4 of 12
Step 5 Position one side of the Paired COMPÄSSO
channels on the floor, following their part
identifications. Using the reference dimen-
sions on the drawing, align the Paired
C
OMPÄSSO Channels with the hanger wire
locations.
Step 6 Transfer the hanger wire locations to
the top of the Paired C
OMPÄSSO Channels.
These markings indicate where each
hanger bracket will be attached.
Step 7 Snap the first channel onto its corresponding
hanger brackets.
Tip: Start at an intersection; if there is
no intersection, start near the middle of
the assembly.
Installation
Instructions
Basic Installation