Manual

PROCEDURE
1. CAUTION: ENSURE THAT THE PISTOL IS NOT
LOADED.
2. Strip for cleaning as previously described.
NOTE: Avoid contact between cleaning rod and muzzle
as resultant wear will reduce accuracy. To avoid
damaging the muzzle always clean from breech end
forward.
3. Attach cotton flannel patch to end of cleaning rod,
insert it in breech and pass rod and patch down through
barrel. Repeat, changing patches until last patch comes
out clean.
4. Visually inspect barrel; if it is clean, proceed directly to
step 7, but if it remains dirty, continue with step 5.
5. *(NOTE:This item should be applicable only after
firing). Attach brass wire bristle brush to cleaning rod
and dip brush in gun cleaning solution. Thoroughly scrub
out barrel, passing the brush all the way through before
reversing the movement. If you try to change direction
with brush in barrel, the brush will stick.
6. Repeat steps 3 and 4 above.
7. Clean rear face of barrel and face of slide, using a
small toothbrush. SAFETY DEPENDS ON YOU
36