Manual

CAUTION:YOU COULD DAMAGE YOUR PISTOL WHEN

YOU FIRE, OR ATTEMPT TO FIRE IF THE RECOIL SPRING

PLUG IS NOT CORRECTLY SEATED AND LOCKED AS

DESCRIBED ABOVE.

7. After assembling the pistol, check its function as

follows: Remove Magazine. Pull the slide back fully and

let it go. It should fly forward and close over the empty

chamber. The hammer should stay cocked. Push the

safety up and squeeze the trigger. The hammer should

stay cocked. Push the safety down and squeeze the

trigger. The hammer should fall. Pull the hammer back

slightly without touching the trigger. You should hear a

click as the sear slips into the half cock notch. Lower the

hammer to engage the half cock notch.

Rotate the hammer rearward slightly without touching the

trigger. While holding the hammer in this position, slightly

squeeze the trigger to get by the front of the half cock

notch and then hold the trigger fully rearward znd releas-

ing the hammer down while controlling with the thumb

on to the firing pin stop. Finally, release the trigger.

Insert an empty magazine. Pull the slide back fully and let

it go. It should NOT fly forward. Hold slide, push down

on the slide stop and ease the slide fully forward. Put

your thumb on the hammer, squeeze the trigger and

ease the hammer down onto the firing pin stop, again

while controlled by the thumb.