Manual

IMPORTANT: Do not strip your pistol further than

previously described. Do not remove or alter parts,

particularly safety parts. If additional maintenance is

required, see”Service and Repair” later in this instruction

manual.

ASSEMBLING AFTER CLEANING

1. With slide upside down and barrel link forward,

assemble barrel into the slide, as in Figure 8.

2. (See Figure 9). Place barrel bushing over muzzle of

barrel and into slide until it is flush with the face of the

slide, (STEP 1). Turn bushing clockwise as far as it will go.

(STEP 2).

3. Place the recoil guide into the recoil spring so that the

closed end of the spring is up against the collar of the

guide.

Assemble the recoil spring and guide into the slide by

pushing the open end of the spring through the slide

from the rear, (STEP 3). Position the arched portion of

the recoil spring guide over the outside , surface of the

barrel, (STEP 4).

4. Cock the hammer. Run the slide onto the receiver.

Look through the slide stop hole in the side of the

receiver. Move the slide along the receiver until you see

the hole in the barrel link line up with the hole in the side

of the receiver. Insert the slide stop through the hole until

it is almost home; (See Figure 10).