Specifications

Start-Up Instructions

1. Plug the valve into an approved power source.

2. When power is supplied to the control, the screen will display “INITIALIZING WAIT

PLEASE” while it finds the service position.

3. If screen is locked, press MENU for 3 seconds to unlock. Press SET/REGEN and hold for 3

seconds to initiate a manual regeneration. An option for delayed or immediate regenera-

tion will appear. Press the SET / REGEN button again and “Delayed” will begin flashing,

press the down arrow button to have “Immediate” flash. Press the SET / REGEN button

and then press the MENU button and the valve will immediately start moving to the

BACKWASH position.

4. Open the inlet on the bypass valve slowly and allow water to enter the unit. Allow all air

to escape from the unit before turning the water on fully then allow water to run to drain

for 3-4 minutes or until all media fines are washed out of the softener indicated by clear

water in the drain hose.

5. Press any button to advance to the BRINE position. Check the water level in the brine

tank to insure the valve is drawing brine properly.

6. Press any button to advance to the RINSE position. Check the drain line flow. Allow the

water to run for 3-4 minutes or until the water is clear.

7. Press any button to advance to the REFILL position. Check that the valve is filling water

into the brine tank. Allow the valve to refill for the full amount of time as displayed on the

screen to insure a proper brine solution for the next regeneration.

8. The valve will automatically advance to the SERVICE position. Open the outlet valve on

the bypass, then open the nearest treated water faucet and allow the water to run until

clear, close the tap and replace the faucet screen.

9. Add salt into the cabinet tank.

10. Program time, date, hardness and people into controller using Programming Instructions

Programming Instructions

Key Pad Configuration

MENU BUTTON “ ”: The function of this key is to enter the level one programming

mode where the valve settings can be adjusted.

SET / REGEN BUTTON “•”: This button has two functions. The first is to initiate a manual

regeneration by holding the button for 3 or more seconds. The

second function is while in programming mode, pressing this key

allows the user to change the value of each setting.

UP / DOWN “ ”: These buttons are used to increase or decrease the value of the

settings while in the programming mode.