Specifications

Sanitizing Procedure

Care is taken at the factory to keep your water softener clean and sanitary. Materials used

to make the softener will not infect or contaminate your water supply, and will not cause

bacteria to form or grow. However, during shipping, storage, installing and operating, bac-

teria could get into the softener. For this reason, sanitizing as follows is suggested when in-

stalling.

Sani-System Liquid Sanitizer Concentrate

Item# 80030021—Softener Sanitizer 0.25 fl.oz (24 Pack)

1. Be sure to complete all installation steps, including programming.

2. For effective and complete sanitization, EcoSmart recommends Sani-System Liquid Sani-

tizer Concentrate. Pour one 0.25 fl. Oz. package into the brine well located in the cabinet

tank. (Alternative use 3/4 oz of common 5.25% household bleach)

3. Start an immediate regeneration. If screen is locked, press MENU for 3 seconds to

unlock. To initiate an Immediate Regeneration, press the SET / REGEN button for 3 sec-

onds, an option for Delayed or Immediate Regeneration will appear. Press the SET / RE-

GEN button again and delayed will begin flashing, press the down arrow button to have

Immediate flash, press the SET / REGEN button and then press the MENU button and the

valve will immediately start into manual regeneration.

4. The Softener Sanitizer Solution is drawn into and through the water softener to sanitize

it. This sanitizing regeneration is over in about two hours. Then, soft water is available

for your use.

NOTE: Sanitizing is recommended by the Water Quality Association for disinfecting. On

some water supplies, they suggest periodic sanitizing.