Manual

shoulder and the barrels pointed toward your
intended target, place your trigger finger on the
trigger. The combination rifle/shotgun will fire
when you pull or squeeze the trigger with the
requisite force. See Figure 29.
5) If you wish to fire a second shot from the second
barrel, you must move your finger to the other
trigger and pull or squeeze that trigger. The
second barrel will then fire.
W A R N I N G
Once you have stopped firing the combination rifle/
shotgun, immediately pull the trigger block safety
back to the “on” or “safe” position. Then follow the
unloading instructions above while keeping the
muzzle pointed in a safe direction.
DIRECTIONS FOR DISASSEMBLY OF THE
COMBINATION RIFLE/SHOTGUN:
1) Make sure the firearm is unloaded (FOLLOW
UNLOADING INSTRUCTIONS) and pointed in
a safe direction.
2) Make sure the trigger block safety is engaged in
the “ON” or “SAFE” position. See Figure 30.
3) Make sure the barrel assembly is locked into the receiver and the action
closed. The top lever should now be in the center position. Remove the
forend from the barrel by pulling out the mechanical lever in the lower center
of the forend and removing the forend in a downward outward swinging
motion. See Figure 31. Never force the forend off the barrel and receiver.
4) With the barrel and receiver supported with one hand, push the top lever
fully to the right and tip the barrel assembly down until it disengages from
the receiver. Check the barrels for damage and obstructions after removal.
See Figures 32a, 32b and 33.
17
Figure 29
Figure 30
Figure 31
Figure 32a Figure 32b Figure 33