Specifications

2-2 MP/8 V.34: Getting Started
Installing the MP/8 V.34
The Total Control MP is designed to be used either stand -alone
or mounted in a standard 19 -in. equipment rack. Follow the
instructions for the installation method that suits your needs.
Important!
♦ Do not block the vents on the right side of the unit.
♦ Keep the unit in a dry place at room temperature.
♦ If using the unit as a stand -alone, keep it on a flat surface.
This will leave room above and below for adequate
ventilation.
♦ When installing more than one chassis in an equipment
rack, leave room above and below them for adequate
ventilation.
Stand-Alone Installation
1 Find the rubber feet that are included with the package.
2 Turn the MP/8 V.34 over and attach a rubber foot in each
of the recesses in the four corners of unit.
3 Turn it back over and place it on the surface where it will be
used.
4 Go to Setting the DIP Switches.
Installing the Unit in a Rack
1 Find the mounting brackets (2) and the screws (4) that are
included with the package.
2 Line up the holes in the mounting bracket with the holes in
the MP/8 V.34, and then screw the bracket in place. See
Figure 2-1.