User guide
Serial ATA 4-Drive NAS
User Guide
Managing Your Storage System - 71
4. Click Apply.
The system date, time, or time zone In Date, enter or select the desired month, date, and year.
In Time, enter or select the desired hour, minute, and second.
In Time zone, select the desired time zone.
Note: The storage system time does not automatically change to reflect
daylight saving time. Even if the storage system and Active Directory
server are in the same time zone and have the same time, errors might
occur if the Active Directory server adjusts for daylight saving time. In this
case, you must change both the time zone and time on the storage
system. For example, if the Active Directory server time is 2:00 P.M. in the
Central Time zone (GMT-06:00), you would set the storage system time
zone to Eastern Time (GMT-05:00) and then set the time to match the
Active Directory server (14:00). If you do this, do not synchronize the
storage system with an NTP server, as the time is readjusted based on
the time zone.
NTP server name or IP address In NTP server name or IP address, enter the name or IP address of the
Network Time Protocol server from which the
storage system should set
its time.
You can use a name only if it is resolvable.
The storage system will synchronize its time with the NTP server every
hour.
The administrator name or password In Administrator name, enter the user name to use for logging in to the
Web User Interface.
In Password and Confirm password, enter the password to use for log-
ging in to the Web User Interface. It cannot contain multi-byte words. This
means that you can only enter ASCII characters whose code values are
less than 128.
The user name and password are case-sensitive.
To reset the password to its factory default:
1. If the storage system is running, shut it down by pressing the
power button unit for approximately 5 seconds.
2. After the storage unit has shut down, press and hold the
power button until the power LED comes on, and then release
the button.
3. As soon as the LEDs for all of your disks have come on, press
and hold the power button for 2 seconds, and then release the
button.
The default login administrator name is admin.
The defalut login password is storage.
To change this Do this