User guide
Serial ATA 4-Drive NAS
User Guide
Troubleshooting - 146
Microsoft iSCSI Initiator will not match the recovery password on the storage system.
To address this issue, you must reconfigure the Microsoft iSCSI Initiator to use the password that you
specified on the storage system. If you are using the recovery CD, you must do this after you recover your
system disk. If you are booting remotely, you must do this while in Network Boot Mode (before you recover
your system disk) and again after you recover your disk and boot locally.
To reset the recovery password in the MIcrosoft iSCSI initiator:
1. Windows Vista or XP: click Start > All Programs > Microsoft iSCSI Initiator > Microsoft iSCSI Initi-
ator.
Other Windows operating Systems: click Start > Programs > Microsoft iSCSI Initiator --> Microsoft
iSCSI Initiator.
2. Click the Targets tab.
3. If more than one target appears in Targets, select the one that contains the name of the storage sys-
tem.
The Status should be Disconnected.
4. Click Log On.
5. Click Advanced.
6. Select CHAP logon information.
7. In User name, type your computer name in all capital letters.
8. In Target secret, type the recovery password that you specified on the storage system.
9. Click OK on the Advanced Settings and then the Log On to Target dialog boxes.
The Status of the target should now be Connected.
10. Click OK on the iSCSI Initiator Properties dialog box.