User guide

Serial ATA 4-Drive NAS
User Guide
Disk Configurations - 131
Responding to RAID Failure
When disk removal/failure causes the entire RAID to fail, the Disk Change Notification page appears
when you access the Web User Interface or refresh the browser window:
Take the appropriate action:
Swapping Hard Disks
If you are using RAID 5 + spare or RAID 10, you can move the hard disks from one slot to another whether
To do this Do this
Scan the storage system again and
update the information on the page
Click Scan.
Re-install the same disk Click Shut Down.
After the storage system shuts down, re-install the same disk and then
restart the system.
Note: If you removed multiple disks, be sure to re-install them in the
opposite order than you removed them.
Reconfigure the storage system
using the available disks
Click Reconfigure Disks and complete the system setup pages (as
described in “Step Five: Configure your Storage System” on page 20).
Caution: Reconfiguring the storage system deletes all user information and
all data on all the disks.