User guide

Serial ATA 4-Drive NAS
User Guide
Protecting Local Disks - 108
1. Click Restore.
2. In Protected disk, select a disk whose backup resides on the storage system whose recovery pass-
word you need to change.
To double-check your selection, click Status. The name of the storage system appears in the Backup
location area. Then click Restore to return to the Restore page.
3. Click Recovery Password.
4. In Recovery password, enter the desired password.
This password must be 12–16 characters long. It cannot contain multi-byte words. This means that you
can only enter ASCII characters whose code values are less than 128.
5. In Retype your password, enter the password again.
6. Click OK.