User guide
Serial ATA 4-Drive NAS
User Guide
Protecting Local Disks - 100
What to do next:
3. When the Add Storage System dialog box appears, DiskSafe Express automatically scans your sub-
net for storage systems. Any storage systems that are detected appear in the Discovered storage
systems
list. (It might take a few seconds to complete the scan. You can cancel it at any time by click-
ing Cancel on the scanning message box.)
From Discovered storage systems, select the storage system where you need to back up the
selected disk. The name of the storage system automatically appears in Storage system name or IP
address.
If no storage systems are automatically discovered, or if you need to back up your disk to a different
storage system, enter the name or IP address of the desired storage system in Storage system name
or IP address.
Then click OK.
4. From Backup locations, select the storage system to use for backups of this disk or partition. (The
In this case Go to this step
You never previously completed the Protect a Disk wizard 3
You previously completed the Protect a Disk wizard and connected to a storage system
4
You previously protected this disk and removed protection (as described in “Removing
Protection” on page 122)
5
Note: You can enter a storage system name only if that name is registered with a DNS server on
your network.
Note: If an authentication error occurs, make sure the name or IP address of the storage system is
correct, and that your computer is connected to the network.