User guide

USR4204 User Guide
Page 43 of 69
Config Security Menu (Main Menu  Y  U)
At the top of the Configure Security Menu is the menu name. A list of valid commands, text,
and status follows. Invalid commands are ignored.
Use a Select command (see below) to set up the Administrator and up to 15 User accounts.
'0' Select Admin
Navigate to the Administrator Menu with this command. It is the only command available on
this menu if security is off. Use this command to setup the Administrator account and turn
on security.
Batch Mode Command: None
'1'–'9' and 'A'–'F' Select User
Navigate to the corresponding User Menu with this command. The current User status
(ON/OFF) is shown in parentheses next to the User name. Use this command to setup a
User account.
NOTE: To disabled a user or re-enable a locked-out user, select the user then
Toggle the User Enable status to 'ON'.
Batch Mode Command: None
'-' Return to Configure Parameters Menu
Navigate back to the Configure Parameters Menu with this command.
Configure Security Menu (current enabled state in parentheses below)
CMD CMD
'0' Select "Admin Username " Admin '8' Select " " (OFF)
'1' Select " " (OFF) '9' Select " " (OFF)
'2' Select " " (OFF) 'A' Select " " (OFF)
'3' Select " " (OFF) 'B' Select " " (OFF)
'4' Select " " (OFF) 'C' Select " " (OFF)
'5' Select " " (OFF) 'D' Select " " (OFF)
'6' Select " " (OFF) 'E' Select " " (OFF)
'7' Select " " (OFF) 'F' Select "User 15 " (ON )
'-' Return to Config Parameters Menu '&' Remove ALL Accounts