User guide

USR4204 User Guide
Page 39 of 69
'X' Change Char for Xoff
Change the character used for Xoff flow control with this command. It navigates to the
Change Character screen.
Default: 13h
Hexadecimal 13 is ASCII character ^S (Ctrl-S)
Batch Mode Command: HX=
Valid characters: # $ % ( ) * - . / : ; < > ? @ [ \ ] ^ _ { | } ~
Or any of the following control characters:
A B C D E F G I K L N O P Q R S T U V W X Y Z \ ] ^ _
'W' Enter Login Banner
When security is enabled, the USR4204 will present this greeting previous to the login
prompt if security is enabled. This command is available only when security is on and
navigates to the Change Banner screen. The banner may be up to 64 displayable characters
in length.
Default: USRobotics Console Server & Power Switch
Batch Mode Command: NL=
Valid range: up to 64 displayable characters (zero characters nulls the banner)
'Y' Enter Security Banner
If security and the security banner are enabled, the USR4204 will present a security banner
prior to the login banner. This command is available only when security is on and navigates
to the Change Banner screen. The banner may be up to 256 displayable characters in
length. Each occurrence of '\n' (newline) will be replaced with a carriage return/line feed
pair.
Default: empty (nulls)
The security banner is enabled or disabled by the 'B' command in the Configure Parameters
Menu.
Batch Mode Command: NS=
Valid range: up to 256 displayable characters (use \n for CR/LF, zero characters nulls the
banner)
'F' Toggle S/W Flow Control
Enable or disable Xon/Xoff flow control for the terminal port and all serial ports with this
command.
Default: Off