User guide

USR4204 User Guide
Page 38 of 69
'S' Change Char for Escape
The USR4204 will close a connection to a serial port when it receives the Escape Sequence
on its terminal port. Change the received Escape character with this command. It navigates
to the Change Character screen.
The received Escape Sequence may be disabled by programming this character to a control-
\. To enter control-\ in the Change Character screen, hold down the Ctrl key and press \
Default: "-"
ASCII character ^\ (Ctrl-\) is Hexadecimal 1C
Batch Mode Command: HS=
Valid characters: # $ % ( ) * - . / : ; < > ? @ [ \ ] ^ _ { | } ~
Or any of the following control characters:
A B C D E F G I K L N O P Q R S T U V W X Y Z \ ] ^ _
'M' Change Char for Menu
Change the character for the Menu command with this command. It navigates to the
Change Character screen.
Default: "-"
Batch Mode Command: HM=
Valid characters: # $ % ( ) * - . / : ; < > ? @ [ \ ] ^ _ { | } ~
Or any of the following control characters:
A B C D E F G I K L N O P Q R S T U V W X Y Z \ ] ^ _
'N' Change Char for Xon
Change the character used for Xon flow control with this command. It navigates to the
Change Character screen.
Default: 11h
Hexadecimal 11 is ASCII character ^Q (Ctrl-Q)
Batch Mode Command: HN=
Valid characters: # $ % ( ) * - . / : ; < > ? @ [ \ ] ^ _ { | } ~
Or any of the following control characters:
A B C D E F G I K L N O P Q R S T U V W X Y Z \ ] ^ _