User guide

USR4204 User Guide
Page 37 of 69
Configure Parameters Menu (Main Menu  Y)
At the top of the Configure Parameters Menu is a banner that displays the current system
parameters. Directly below the banner are the menu name, the firmware version number
and date, the serial number of the USR4204, and a firmware checksum. Below that is a list
of valid commands and text. Invalid commands are ignored.
'T' Change Inactivity Timeout
The USR4204 will close a serial port if no data passes in or out of the terminal or serial port
before this inactivity time lapses. If security is enabled, the session will also logout.
Valid range: 0 to 255 decimal minutes (0 disables the timer) Default: 005
Batch Mode Command: HT=
Valid range: 00 to FF (hex minutes, 00 disables the timer)
'R' Rename
Rename the USR4204 with this command. It navigates to the Rename screen. The USR4204
name may be up to 32 displayable characters in length.
Default: USR4204
Batch Mode Command: NN=
Valid range: up to 32 displayable characters (zero characters nulls the name)
T/O Esc Menu Xon Xoff Flow Pass Echo AutoCR DCD Banr
005 - - ^Q ^S OFF OFF ON ON OFF OFF
----------------------------------------------------
Configure Parameters Menu Ver 1.17 05/29/14 S/N: 1ME4Z7PM0004 C/S: A8D5
CMD CMD
'T' Change Inactivity Timeout 'R' Rename System
'S' Change Char for Escape 'M' Change Char for Menu
'N' Change Char for Xon 'X' Change Char for Xoff
'W' Enter Login Banner 'Y' Enter Security Banner
'F' Toggle S/W Flow Control 'P' Toggle Xon/Xoff Pass Thru
'E' Toggle Command Echo 'A' Toggle Auto CR
'D' Toggle DCD Override 'B' Toggle Security Banner
'L' Toggle LF Pacing (ON ) 'J' Toggle Strong Password (OFF)
'U' Config Security '&' Load Factory Parameters
'-' Return to MAIN Menu '!' Flash New Code