User guide

USR4204 User Guide
Page 30 of 69
~& Restore Factory Settings
Enter this two character sequence to restore the USR4204 to factory parameters and clear
all accounts & banners. Even though the ~& command is not shown on the Main Menu, it is
always available for Administrators at the Main Menu.
Batch Mode Command: &
~V Toggle Alternate Menu Mode
Enter this two character sequence to toggle the USR4204 between the Main Menu and the
Alternate Main Menu. Even though the ~V command is not shown on the Main Menu, it is
always available for Administrators at the Main Menu.
Batch Mode Command: FV=
Valid values: 1=on, 0=off
Alternate Main Menu
The Alternate Main Menu offers alternate power port commands that may be preferred by
some Users. All other commands remain as described for the Main Menu.
'1'- '2' Enable Power Port
These commands each control a USR4204 power port. When an enable command is
entered, power from the mains power input is connected (regardless of the previous state)
to the corresponding output after entering a ‘Y’ at the “Are you sure?” prompt. The current
power port state (ON or OFF) and RMS load current are shown in parentheses next to the
port name.
T/O Esc Menu Xon Xoff Flow Pass Echo AutoCR DCD Banr
005 - - ^Q ^S OFF OFF ON ON OFF OFF
----------------------------------------------------
MAIN Menu "USR4204 " Logged In: "Admin Username "
CMD
'A' Connect "Console A "( 9600 None )
'B' Connect "Console B "( 9600 None )
'C' Connect "Console C "( 9600 None )
'D' Connect "Console D "( 9600 None )
'1' Enable "Power 1 "(ON 0.0 Amps)
'2' Enable "Power 2 "(ON 0.0 Amps)
'Q' Toggle Cellular Mode (OFF) '5' Disable 1
'W' Arm Ctrl-B for Break '6' Disable 2
'X' Logout 'P' Change Password
'Y' Config Parameters
'Z' Config Ports
'M' Reboot 1
'-' Refresh MAIN Menu 'N' Reboot 2