User guide

USR4204 User Guide
Page 29 of 69
'X' Logout
The Logout command ends a secure session and sends the Login screen to the terminal. It
is available only when security is on.
Batch Mode Command: None
'P' Change Password
This Change Password command allows Users to change their own password. Use the
command to enter a new password on the Change Password screen. The password may be
up to 13 displayable characters in length. Passwords are case-sensitive.
Batch Mode Command: None (Users can’t access Batch Mode)
'Y' Configure Parameters
Navigate to the Configure Parameters Menu with this command.
Batch Mode Command: None
'Z' Configure Ports
Navigate to the Configure Ports Menu with this command.
The Configure Parameters and Configure Ports commands are available only
to the administrator, or if security is off.
Batch Mode Command: None
'-' Refresh Main Menu
Refresh the Main Menu banner with current system parameters and update current status
for each port with this command.
The spacebar or the Enter key may also be used to refresh the Main Menu.
Batch Mode Command: None
~B Enter Batch Mode
Enter this two character sequence to put the USR4204 into Batch Mode. Even though the
~B command is not shown on the Main Menu, it is always available for Administrators at the
Main Menu. Exit Batch Mode with the ~ Batch Command.
Batch Mode Command: None